Hi all;
I was running writelog 10.65, MMTTY standalone, and DX4WIN on my windows 98
computer and all of them talked to my IC-756PRO2. I then installed 10.75N and
was having all sorts of strange things with writelog. Everything else still
worked fine. I had a lot of writelog file and temp files and I decided to
deinstall writelog. After the deinstall there were still a lot of writelog
modules on the system. I deleted all the stray files I could find including
writelog.ini and wlogkey.ini. I then reinstalled ver-10.75N and was able to
configure writelog to key cw and rtty without any problems. The problem is
writelog doesn't talk to the PRO2. The config in writelog is the same as the
other programs that work. Writelog knows the rig is there because when I tune
PRO2 frequency the radio button shows khz:LSB. The Pro2 is in CW mode. When I
stop tuning the display goes back to "no rig". The baud rate is 9600 and com2
is defined as 8 bits with 2 stop bits. I could use some suggestions as I
have exhausted my bag of tricks.
Thanks Dave N4IG
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|