Hi Gary,
Sorry that wasn't the total solution for you. I know that the 'LSB is Really
FSK' thing has bitten me a few times and has caused me confusion as to why the
macros were not being sent out. As for LSB versus USB, I have read that it
really doesn't matter which sideband you use for PSK operation, so I set my
ICOM 756 ProIII to LSB or LSB-D, and everything works OK. Unfortunately, I
don't have the same setup as you as far as the interface is concerned. I am
using a US Interface Navigator. It's internal sound card generates the audio
tones needed by the program that are sent to the transceiver, as long as I have
'Sound board AFSK' set on, as you do, and I have the 'RF OUT' on the navigator
set to a level that keeps the ALC low. RF OUT on the navigator is really just a
volume output setting for the built-in sound card. It sounds to me like the
audio tones are not getting to the transceiver from the interface. Does the
MKII have it's own monitor function, to verify that the tones a
re being generated? I verified that my setup works OK with 10.78K, so I think
you can eliminate that as the problem. Good Luck tracking it down!
Bob, WB2COY
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|