In Tools/Keyboard Shorcuts
* choose Rig1Command(n) -supposed the radio you want to send the command to
is on the first COM slot i.e. first block in Ports Setup- in "Command to run"*
type 10 in "Rig Command Number"* type F10 in "Shortcut Keystroke"
that's it
"73, Juan EA5RS----Mensaje original----De: k2mk@comcast.netFecha: 10/09/2010
14:28Para: "WriteLog Reflector"<WriteLog@CONTESTING.COM>Asunto: Re: [WriteLog]
Elecraft K3 Radio and Keyboard CommandHi,I followed the same procedure as you
and had a similar failure trying to evoke a SPOT command (SWT42;) using the F12
key with 10.79D. I get an error message in the status area:Error result -3
sending rig command (10)After several hours of negative results I decided to
wait until 10.80 is released.73,Mike K2MKI would appreciate some assistance
with the Keyboard Commands function withmy K3 Radio. My objective is to create
Function Keys (i.e. F10) that playsthe DVK messages, etc.In the Writelog.ini
files, I created two lines [Elecraft_K3_commands] andMacro_10=k31;swt21; (this
should be the command sent to the radio to key theDVK message #1). Where to I
tell Writelog that the F10 key should beMacro_10 ? I tried making a change in
the Keyboard Shortcuts parameters, butthis did not work.
Thanks - KD3TB _______________________________________________WriteLog
mailing
listWriteLog@contesting.comhttp://lists.contesting.com/mailman/listinfo/writelogWriteLog
on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|