Jim, excellent question. I'm not home right now but somehow I don't think the
"scope" reference in the writelog.ini file is for that particular display but I
could be wrong.
I know when I activate a DXP-38, a scope display window pops up. The display
is
basically useless and the only way to get rid of it is do double-click on it to
get a top bar to appear with the X to close it out. It's annoying but you can
move it around. Is this scope display for the KT4FY multimodem needed to tune
signals?
When I get home, I'll do a screen shot of the DXP-38 scope display and see if
it's the same display window as you are getting.
Don AA5AU
----- Original Message ----
From: KC4HW/Jim <kc4hw@centurytel.net>
To: writelog@contesting.com
Sent: Mon, February 28, 2011 6:04:54 AM
Subject: [WriteLog] TU Type: KT4FY Multimodem
I have one of these unit and when selected a digital tuning scope pop
up.
This scope tuning dialog does not have a Window's top info border.
So you can not pick it up with the mouse and move it around.
I found in Writelog.ini reference to:
[SCOPE}
X=186
Y-752
I am guessing that this is a reference to where it currently locates on
the screen, which is the upper left hand near the corner. Can
someone confirm this?
If so, I would like to move it, but not sure how...can someone give me
a starting place to say move this dialog near the lower right hand
corner of the monitor?
thanks.
Jim/KC4HW
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|