Thanks to all that provided input. I did get a fix by selecting:
Kenwood
9600 baud
I had originally left the setting at auto-select (did not work).
I did try the Elecraft settings with no joy.
All is well and ready for NA CW Sprint!
73,
Dave, K7JJ
Dave Earnest
----- Forwarded Message -----
From: JE Brown <W4LC@fuse.net>
To: Dave Earnest <k7jjdave@yahoo.com>
Sent: Monday, September 5, 2011 5:10 PM
Subject: Re: [WriteLog] TS-590S with Writelog
I am running 1087E, and get all functions with TS-2000 selected. However, I
have read that some have had success selecting Elecraft K2. You might try that.
----- Original Message ----- From: "Dave Earnest" <k7jjdave@yahoo.com>
To: <writelog@contesting.com>
Sent: Monday, September 05, 2011 7:14 PM
Subject: [WriteLog] TS-590S with Writelog
I'm just integrating a new 590. It works fine with DX4WIN using the TS-870 rig
selection.
However, in Writelog 10-87E, I get no rig/freq control using Kenwood or Kenwood
TS-850. With TS-2000, I do get mode control.
I do get freq readout with MMTTY stand alone and am o.k. with freq/mode control
with DX4WIN. I am running Win 7/64 bit.
Any suggestions would be welcomed.
73,
Dave, K7JJ
Dave Earnest
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|