Found the problem!!! It's the AA6YQ FIR512 profile. When that is selected
it shifts MMTTY back to 45 baud. Using the standard RTTY profile MMTTY
stays set at 75 baud.
73,
Gary AL9A
----- Original Message -----
From: "Gary AL9A" <al9a@mtaonline.net>
To: "Writelog" <writelog@contesting.com>
Sent: September 18, 2011 8:49 AM
Subject: MMTTY 75 Baud setup problem
> Help! My problem with the MMTTY plug-in and RittyRite decode at 75 baud
> is back! I had it working yesterday - this morning it won't decode at 75
> baud. I've tried everything I can think of - rebooted, shut down RittyRite
> and MMTTY and reopened the windows again, shifted RittyRite into Sound
> Board FSK and back to MMTTY. Nothing works! When my messages are sent
> they do not decode properly in RittyRite so I'm not sure what it will be
> like trying to decode off the air. Any suggestions?
>
> 73,
> Gary AL9A
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|