Specify the port in the *RTTYrite* menu then reselect MMTTY as the TU.
The port is passed to the plug-in when the plug-in is initialized.
... Joe, W4TV
On 1/8/2012 1:04 AM, Rick Tavan N6XI wrote:
> I can't get the MMTTY Plug-In for Writelog to allow me to specify FSK.
> rttycontesting.com makes it clear that you must set the COM port first.
> I've done that, even using my one physical port to make sure it's a good
> one, but the SETUP | MISC tab still has the two FSK choices grayed out.
> I have tried uninstalling both the plug-in and MMTTY. Then I reinstalled
> MMTTY in c:\ham\mmtty as suggested and tested it. It works fine, selecting
> COM2 and COM-TxD. Then I reinstalled the plug-in. I ran Writelog and made
> sure that it isn't using COM2 for anything else. On first start, I
> identified the location of the executable as described in the documents. I
> selected COM2. The FSK choices remain grayed out.
> What else have I forgotten to do since the last time I tried this?
> I'm running Writelog 11.01F, a fresh release. Is there a problem with it?
WriteLog mailing list
WriteLog on the web: http://www.writelog.com/