when I switch to the right radio (2) when I hit an F key to send
anything the Tx port in that MMTTY switches to sound (should be
Com-txd, and it was that before hitting the F key. Of course this
results in a steady carrier.
You have probably not specified a FSK port for radio 2 in RTTYrite or
the MMTTY.ini specifies "sound" and is read only so your changes are
not saved between restarts.
What operating system? If Vista/Windows 7, do not install MMTTY in
the "Program Files" directory tree as any ini/configuration file will
be read only.
73,
... Joe, W4TV
On 10/2/2012 11:31 AM, W2LE wrote:
Running Writelog 11.06A, Microham router 8.1.4, MMTTY 1.68A in two
different folders.
I've set up Writelog according to the Microham notes.
MMTTY running without Writelog works fine for each radio, each using
Com-txd.
But running RTTYRITE/MMTTY there are problems.
The left radio (1) works correctly, but when I switch to the right radio
(2) when I hit an F key to send anything the Tx port in that MMTTY
switches to sound (should be Com-txd, and it was that before hitting the
F key. Of course this results in a steady carrier.
To change it back to Com-txd I have to start the stand alone MMTTY for
that radio and change it there.
Any ideas?
Paul W2LE
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|