When using a PK232, you have to edit the writelog.ini file. I found this in the
reflector archives which might help:
http://lists.contesting.com/archives//html/WriteLog/2003-09/msg00034.html
If your writelog.ini file does not have a [PORTS] section, you may need to
create one. Open writelog.ini in notepad. Anywhere in the
file, add these lines EXACTLY AS THEY ARE TYPED HERE:
[PORTS]
Com1=9600,n,8,1,
If you have a [PORTS] section, make the appropriate changes to the Com1 entry
if there is a Com1 entry. It's possible there is an
"x" at the end of the entry. If so, delete the "x", but leave the comma at the
end.
Let us know if this works or not. This was from previous versions of WL. I
don't know if anything has changed as far as a [PORTS]
section is concerned.
73, Don AA5AU
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of Ted
Boerkamp
Sent: Friday, October 12, 2012 6:24 PM
To: Writelog Reflector
Subject: [WriteLog] pk232 problem with clone window
Hello..I am trying to use a pk232 in a receive only situation in a clone window
but
when I try to pick the comport and tnc type I get a message that its trying to
initialize host mode
but then errors out saying "pk232 initialization failed.try again??"
I don't know why this is happening..I can copy rtty no probs using
hyperterminal with comport 1
set to 9600 baud 8,n,1 but now it wont work within writelog.
As a side note..this configuration has worked before for a long time so
something has changed
but I cant figure it out. Any help is most appreciated.
Thanks
Ted VE3SS
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|