On the main writelog screen. Under Entry. Check >>> Enter sends exch/QRZ.
In writelog.ini.
CQFunctionKey=11 << CQ test
SendCallExchangeKey=3 << the exchange 59903
QrzFunctionKey=4 <<<< This is your end msg. e.g.
QSL VE2LX WS7I CQ
MoveNextOnEnter=1
InsertOverridesCall=1
Then for example in RTTY hitting Enter will Call CQ. You can use the
INSERT Key to grab the call and send the exchange in RTTY or mouse it.
Then the enter key sends message in F4 and logs it. There must be four
or five different ways to set things up. CW is a little different as is
SSB.
Also the movenextonenter can be used instead of space bars to move
around. But its the main screen that controls the actual enter key.
Which is what I think you were looking for.
Jay WS7I
On 11/19/2013 10:24 AM, G wrote:
In WL archives section I seen an article describing that way of operating
( 3 time hit enter to send exchange + log qso + answer to the exchange )
unknown for me before.
I tried it but can'nt successeed.
((( Can someone tell me how and describe configuration in INI file if need
so. )))
Gilles VE2LX
=============
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|