Ken,
That's a problem. In the writelog.ini file the various windows are
identified by labels such as [DockScreen-Bar0] and [DockScreen-Bar4], etc.
They are not clearly labeled with the names shown in the Window menu item.
Is there any reason you cannot reposition or resize the Check Call window by
dragging it to a new location or dragging on a corner to resize it? In the
Help manual there is a section called "Arranging the Windows" that describes
various ways to move and/or resize the windows. If you need to identify the
specific coordinates of the Check Call window you might try the following.
I've never done it, but it should work.
Open the ini file and highlight the section with all the DockScreen
parameters. Print out this highlighted section for reference. Now, using
the methods described in "Arranging the Windows", move the Check Call window
to a new location, preferably significantly other than its current location.
Now exit WL which should cause it to save the new Check Call window
coordinates to the ini file. Open the ini file again and compare the
DockSreen coordinates with the paper copy you printed earlier. The one with
the changed coordinates should be the Check Call window, assuming you didn't
move or open any other windows.
73,
Gary AL9A
-----Original Message-----
From: Ken Widelitz
Sent: February 06, 2015 7:40 PM
To: writelog@contesting.com
Subject: [WriteLog] Check Call Window Coordinates
Where in Writelog.ini would I find the x and y coordinates that control the
location of the Check Call window?
73, Ken, K6LA / VY2TT
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|