SSB/vox works just fine. so went to options in mmtty and discovered
somehow under DEVICES it was showing -1, changed those to 1 and all
is back to normal again.
In the future, check the "SoundCard" tab in MMTTY | Config rather than
the Misc tab. The SoundCard tab provides a list - with "radio" buttons
for selection - of available sound cards.
Device -1 in the "Misc" tab is the Windows Default card (which should
*never* point to either Line or Headset Mic inputs of microHAM CODEC).
1 is something else (the SoundCard tab will tell you).
In any case, follow the "Configuring microHAM CODEC" section of the
microKEYER II Users Manual and *don't* open the MMTTY (or PSK) Window
of DX4win while running phone (if you expect to be able to record DVK
messages).
73,
... Joe, W4TV
On 7/19/2016 9:22 AM, Courtney Judd wrote:
thanks for the response Joe.... everything was all ok with the
router.... spent a lot of time with it.... ended up deleting everything
and started over with new presets.... problem was still there. Thought
about this several times during the night and decided it had to be a
dx4win issue as that was the only time it showed up. So this morning I
was going over and over the preferences in dx4win and thought about the
rtty/mmtty window being open. I closed it and problem went away. SSB/vox
works just fine. so went to options in mmtty and discovered somehow
under DEVICES it was showing -1, changed those to 1 and all is back to
normal again. Life was much simpler under XP... guess win 10 must have
changed those values. Took me over 5 hours to sort this out... but all
is good now! Thanks for all the suggestions! 73's Cort K4WI
microHAM Support (W4TV) <mailto:support@microham.com>
Tuesday, July 19, 2016 8:03 AM
Is microHAM Router properly following the frequency and mode of your
transceiver?
What are the settings on the Audio Switching tab in microHAM Router?
Is the Voice/Digital settings selector set to "Use Voice Settings"?
Is "Computer generated audio fed to:" set to "Microphone jack, DVK
Control" for voice?
Your symptoms indicate the audio is set improperly with the mic
routed *through* the sound card/computer. When MMTTY opens, the
sound card input is switched from mic to line disabling your audio.
73,
... Joe Subich, W4TV
microHAM America, LLC.
http://www.microHAM-USA.com
http://groups.yahoo.com/group/microHAM
support@microham.com
This message, including any attachments, may contain proprietary,
confidential or privileged information for the sole use of the
specific individual(s) to whom it is addressed. You are hereby
notified that any disclosure, copying, distribution, or use of this
message is prohibited. If you have received this message in error,
please immediately notify the sender by reply e-mail and delete it.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|