I normally only see this message when I open a log that was networked with
another computer (I run SO2R with two PCs) and I try to add a contact when
WriteLog is not networked.
When I don't run SO2R and start a new log, log contacts, close it, then reopen
and log more contacts, I do not get this message.
I can only guess that something might not be set correctly in your INI file.
You can edit your current INI file and see if there is a [NETWORK] section in
there or not (I don't remember if there is or not and not at home to access my
files). If there is a [NETWORK] section, try deleting it. You can also try
using a defaut INI file (save your current INI or just rename it).
Information on how to work with INI files can be found here:
http://www.rttycontesting.com/tutorials/writelog/version-12/
73, Don AA5AU
From: Brian Miller <bdm556@bigpond.com>
To: writelog@contesting.com
Sent: Friday, January 6, 2017 7:46 AM
Subject: [WriteLog] Prompt to restore network when using a non-networked log
When I reopen one of my logs (a general DX log) and attempt to enter a new
QSO I receive a pop up message stating"You are adding a QSO to networked
log. Restore the network now?". As far as I'm aware I have never connected
this log in network mode. It is not clear to me why this message is being
displayed now or how to stop it being displayed. I have observed the problem
in versions 12.08c and 12.12c.
Any thoughts on how to resolve this?
73, Brian VK3MI
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|