Thanks. That did the trick, but I have been using the same template for 10
years and never had to edit the sub-bands.
But fixed now.
Joe K0BX
On Fri, Aug 4, 2017 at 10:44 PM, <k2qmf@juno.com> wrote:
> Hi Joe,
>
> I know the answer to this issue!!!
>
> Go to Edit SubBands in the writelog directory.
>
> Edit the RTTY frequencies to move them up to their subband areas.
> For instance, move 20 meters to 14070 instead of 14000 and so on...
>
> Then packet spots will work right!!!
>
> 73,
> Ted K2QMF
>
>
> On Fri, 4 Aug 2017 21:18:39 +0000 joeduerbusch <k0bx@arrl.net> writes:
> > I am using Version 12.18F of WL.
> > When I click on a CW spots the Packet Spot window , it takes me to
> > the
> > correct frequency but changes the mode to RTTY?
> >
> > The Template that I am using is the "General DXCC Tracking Log
> > keeper"
> > which I have been using for years.
> >
> > Should I go back on Version or is there a fix? Maybe I am the only
> > one
> > that has the problem?
> >
> > Joe K0BX
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
> >
>
> ____________________________________________________________
> Remove Your Eye Bags In 1 Minute!
> Daily Tiply
> http://thirdpartyoffers.juno.com/TGL3141/5984f909cac2d790929ecst04vuc
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|