There has been a discussion about this recently over on the RTTY list.
Summary is that jitter makes the decoder at the other work harder by
reducing SNR, but when conditions are good you won't know the difference.
I've also been using the same setup as yours successfully, but I'm looking
at other ways like TinyFSK for several reasons - 73 jeff wk6i
ps: http://lists.contesting.com/mailman/listinfo/rtty if you want to go
look at the discussion, it was within the last couple weeks or so.
On Fri, Mar 9, 2018 at 10:34 AM, Jim Iori <NU4Y@comcast.net> wrote:
> I have used MMTTY within Writelog for years. Always used FSK from a
> com-port with a simple transistor
>
> switch. Used on old TS-930, TS-950 and IC-756PROII. Many contests, much
> DX. Never had a problem.
>
> I like using FSK because of filters available with all of these rigs.
>
> Also do not have to set an offset for the packet spots.
>
> Just my 2 cents.
>
> Jim / NU4Y
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
--
Jeff Stai ~ wk6i.jeff@gmail.com
Twisted Oak Winery ~ http://www.twistedoak.com/
Facebook ~ http://www.facebook.com/twistedoak
RTTY op at W7RN
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|