Monitoring works just fine here on my FTDX 5000 on RTTY. The difference may be
that I use FSK keying not AFSK.
The volume controlled by the Monitor knob sounds very good.
Keith W3KB
-----Original Message-----
From: WriteLog <writelog-bounces@contesting.com> On Behalf Of Joe Subich, W4TV
Sent: Wednesday, December 16, 2020 7:34 PM
To: writelog@contesting.com
Subject: Re: [WriteLog] FTdx 5000 low monitor audio
FTdx5000 monitor audio is a function of the transceiver. The FTdX5000
Operating Manual - page 81 only references Monitor in LSB/USB/AM/FM there is no
reference as far as I can find to a Monitor function for
RTTY/AFSK-based DATA operation. I suggest you contact Yaesu about
a "RTTY/Data monitor" capability.
DK II does not have a separate "sound card monitor" function. You can connect a *powered
speaker* to the u2R Out jack to hear the output of the sound card but that is not a supported
configuration. A non- amplified speaker will not work and will result in "hot mic" type
operation.
73,
... Joe, W4TV
On 2020-12-16 6:53 PM, beaudoin wrote:
GE All
Well I was struggling trying to get my new FTDX 5000 mp going
on RTTY with Microham
Digikeyer 2. I finally got a semi-local to sked a qso ....
It turns out I was ok but what gave me
problem is monitor has no audio to listen to. The local
said his is VERY Low. Is it a setting
we need to look at?
73 BoB WA1FCN
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/