I just logged a "normal" FT8 QSO using the World Wide Digi Contest module
and using "Grid Square & dB Report" and it logged the correct signal reports
(+02 sent and -08 received) and also logged the correct grid and gave me the
correct points.
I was using 12.66D.
Don AA5AU
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of jim
Sent: Friday, August 26, 2022 5:55 AM
To: Writelog@contesting.com
Subject: [WriteLog] Writelog 12.66D
I upgraded to 12.66D and using Digirite 2.2.2.11
In FT8/FT4 this upgrade appears to have changed the way the report is sent
and received and it is not logging the Grid Square.
Before, the upgrade I would get the SNR for both RX/TX, but since it is
entering 599 for both. Additionally, the Grid Square that was previously
logged is now not being entered at all.
I see the GS when the line decodes but have to manually enter. I do have
"Grid Square & dB Report" selected in DigiRite Settings.
Any help here?
Jim/KC4HW
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|