Hi Don,
yes, that's done.
As a matter of fact if I shut down the RTTY window(s) and open the CW window it
shows the same white noise but, if teh CW signal is strong and clear, does some
decode.
..
Alessandro I2SVA
Il giorno 20/01/23, 21:20 "Don Hill AA5AU" <aa5au@bellsouth.net> ha scritto:
You say "WL is properly configured."
Did you set the RX soundboard in the WL Soundboard mixer control?
Don AA5AU
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of
Alessandro - I2SVA
Sent: Friday, January 20, 2023 7:35 AM
To: writelog@contesting.com
Subject: [WriteLog] RX issue with WL and FlexRadio 6400
Hi all,
I am trying to configure RTTY on WL 12.68H together with Flex 6400 (v3.3.33)
on a Windows 10 pc.
FlexRadio 12.61b driver is installed and WL is properly configured.
MMTTY and 2Tones instances are configured and running.
On TX side is all ok.
On RX side (both MMTTY and 2Tone), the level seems too high and in any case
the RTTY tones are not visible (it looks like white gaussian noise); the
noise is related to the active slice with no decode.
I cannot find any way to sort out from this issue.
Anyone is facing the same problem and can help me? Any parameter to
set/change in the Flex 12.61b driver?
Appreciate community help..!
Thanks, best 73
Alessandro, i2sva
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|