Thing is are you familiar with Writelog's Digirite program.
I am not familiar with Digirite - have never looked at it.
I somehow think my problem is a menue setting with MicroHam DXP.
There are no menu settings in DXP that affect the sound card.
*ANY* sound card software should be configured to use "Line (DXP)"
- Left channel for transmit and DXP RX (DXP) - left channel for
receive (on the main receiver). If you have a dual receiver rig
and the software supports dual receive, the second receive channel
should be configured for the rig's second/sub RX as DXP RX (DXP)
- *right* channel.
Receive audio level should be adjusted *separately* with the encoder
for the main (left) and sub (right) channels. "DXP RX" has *NO*
Windows mixer component so receive level does not respond to any
"slider" in the application or Windows driver/Sound Control Panel.
When I activate Digirite view from inside Writelog it reports
"failed to open wave input" could that be because of a DXP menue
choice?
Again, there is no sound card menu choice in DXP. The error message
you quote would almost certainly indicate a configuration error in
WriteLog/Digirite or that you have disabled application access to the
"microphone" (any audio input) in Windows -> Privacy & Security ->
Microphone.
I *DO NOT HAVE* the current version of Writelog *and* have never
built/installed Digirite. I can not help you there.
73,
... Joe, W4TV
On 8/25/2023 3:11 PM, robert beaudoin wrote:
Good Afternoon Joe
I hate to be a pest but...... your previous response
really got me going with
Writelog and MicroHam DXP. Thanks again ...... Thing
is are you familiar
with Writelog's Digirite program. I somehow think
my problem is a menue
setting with MicroHam DXP. I can not get Digirite to
work with Writelog
I used to enjoy that program when I was able to use
a MicroHam Digikeyer 2.
Digirite ask for sound info. When I activate
Digirite view from inside Writelog
it reports "failed to open wave input" could that be
because of a DXP menue
choice? Information on the web seems to pertain to
OLD ver. of Writelog?
I am down to my last day to figure this out as I was
hoping to enter World Wide Digi
test tomorrow.
In any cas Joe all the best 73 BoB WA1FCN
On 8/24/2023 8:21 PM, Joe Subich, W4TV wrote:
In DXP Setup Set 1.2 "CAT DTR" = None
By default, WriteLog asserts DTR on the CAT port for most current
Kenwood and Yaesu rigs.
73,
... Joe, W4TV
On 8/24/2023 8:11 PM, robert beaudoin wrote:
Good Evening All
Anyone using Writelog and MicroHam DXP FTDX 5K ?
Every time I try to load Writelog PTT comes on and
I can not stop it. I uninstalled
Writelog and then re-installed it same thing? I
just started learning this DXP a few
days ago so far I like Microham Digi Keyer Router
menue better..... I got frequency read out
OK.. MMTY is fine and WSJT is fine...... I
really wanted to use Writelog with Digirite
in World Wide Digi test. I believe I can use
WSJT in contest mode?
Ok thanks for any leads...... 73 BoB
WA1FCN
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|