[Yaesu] FT-1000MP Mic Pin-out

[k7zo@micron.net (Scott Tuthill)]

Can someone e-mail me the mic pin out config
for the FT-1000MP. I have one on order and
want to make an adapter for my DVP cable
which is currently wired for Kenwood.

On the Kenwood, which is also 8 pins,
the pins are:

1 = MIC   2 = STBY  3 = DOWN
4 = UP    5 = 8V    6 = NC
7 = GND/MIC  8 = GND/STBY

Thanks, if everything goes right I
should be on the air for CQ 160 SSB
this weekend. If not, then by ARRL SSB
in two weekends.

Scott/K7ZO


--
FAQ on WWW:               http://www.contesting.com/yaesufaq.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 ke7gh@contesting.com
Sponsored by:             Akorn Access, Inc & N4VJ / K4AAA