Yaesu
[Top] [All Lists]

[Yaesu] FT-900 modes

To: <yaesu@contesting.com>
Subject: [Yaesu] FT-900 modes
From: wa3gin@erols.com (Dave Jordan)
Date: Fri, 18 Jun 1999 22:50:38 -0400
Hi Folks,

I have successfully located the resistors to provide variable 'RF Gain
and
Noise Blanking".  I also noticed what I think are two unused pins on the
"Band
Data" jack.  Pins 1 and 2 appear to not be wired to the RF control
board. The
show infinite resistance when I check them with my ohm meter. Can anyone

verifity that the operations manual is in error when it claims that pin
1 is 13 volts and pin 2 is TX Ground?

I've asked Yaesu but they won't be around to answer till next week.

Thanks,
dave



--
FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [Yaesu] FT-900 modes, Dave Jordan <=