I just installed a G-800S rotator and have an interesting problem. When
it's on every once in awhile the pointer moves a little, about 5
degrees, and then goes back to the correct spot. This would happen
every minute or so. I couldn't figure it out, checked the wiring, etc.
and every thing was fine. Then I happened to note that it happened
every time my 2M packet radio, Yaesu FT-8000, transmitted. Go figure a
rotator with an RF problem. Any ideas on how to correct this other than
the usual torid cores on the cable?
73 - Ted - W8TTS
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Administrative requests: yaesu-REQUEST@contesting.com