This will not work.
1. You can´t use the 10 or 50 watt pot, they only work from abt 0-15w resp.
20-70w. Look in the schematic diagram.
2. The "Max power" pot only give 105 watts in the maximum position. ( on my
FT1000MP )
That,s to bad, I also need 120-130 watts for my two 3-500ZG.
73
SM6VVT / Tomas
www.listen.to/sm6vvt
> No problem Will.
>
> There is a pot for each power level located on the audio board. It's
> located on the bottom of the radio on the PCB that runs along the back, but
> the pots are towards the front of this board. I forget how the pots are
> labeled, but I think it's something intuitive. BTW, there is no reason why
> you cant use the 10 watt pot to set it for 120 watts if you dont need the 10
> watt setting but would like to preserve the 100 watt setting,etc. IE, all
> three pots can be set to any power setting.
>
> Yaesu uses 150 watts as the temporary power output to set up some other
> settings during alignment, so you should be able to run 120 no sweat. I've
> actually done that to both of mine as well.
>
> 73, Ty K3MM
>
> ----- Original Message -----
> From: <AA4NC@aol.com>
> To: <yaesu@contesting.com>
> Sent: Saturday, November 04, 2000 2:51 PM
> Subject: [Yaesu] 1000MP power, reflector?
>
>
> >
> > I recently upgraded one of my FT990s for a 1000MP. I understand that there
> is
> > a seperate 1000MP reflector. I would like to get the address for it.
> >
> > Also, is there any adjustment for power above 100 watts output on the 'MP?
> > My 990 will do 110-120 watts which drives the grounded grid amps much
> better.
> >
> > 73,
> >
> > Will
----------------------------------
Tomas Tanbäck
Kärrhed 250
SE 44273 Kärna
Sweden
+46 (0)303 221535
+46 (0)705 221595
sm6vvt@telia.com
www.listen.to/sm6vvt
--
FAQ on WWW: http://www.contesting.com/FAQ/yaesu
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
|