You previously messaged me about a BPF-1 I had offered for sale.
Currently the FT-1000 that it is installed in is for sale. In addition to
the BPF-1 it includes the 600Hz sub receiver filter and Yaesu 3rd IF filters
which fill the 2.4Khz, 500Hz and 250Hz slots. It's been updated by Yaesu to
the Ver 6.0 operating system and it includes the shop manual as well as a
homebrew computer interface.
I'm selling the unit at $2200 shipped CONUS. It might make sense for you to
consider selling your unit and pick this one up.
John Lane, W8KX
> I am looking for the 500Hz and 2.4KHz 3rd IF filters (455KHz).
> Might be interested in a 2.0KHz filter instead. Anyone out there
> upgrade to Inrad filters and have some Yaesus kicking around?
> Or just not need their cw filter?
> Also looking for the Yaesu sub-rx 600Hz cw filter.
> Also looking for a BPF-1.
> Finally, a question: in the sub-rx, is it normal to not be able
> to receive if it does not have the optional 600Hz cw filter and
> is set in cw mode? I find that I have to run mine in USB mode
> when I am operating DUAL cw, in order to get it to work. I would
> think they would have set it up to use the ssb filter when set
> to cw mode? Not so? I do notice there is no diode to clip when
> installing the optional filter, as with the filters in the main radio.
> Thanks, 73 David K3KY
> David Sinclair, K3KY email@example.com
> FAQ on WWW: http://www.contesting.com/FAQ/yaesu
> Submissions: firstname.lastname@example.org
> Administrative requests: yaesu-REQUEST@contesting.com
> Problems: email@example.com
FAQ on WWW: http://www.contesting.com/FAQ/yaesu
Administrative requests: yaesu-REQUEST@contesting.com