Yaesu
[Top] [All Lists]

[Yaesu] new member with a ft-101... (Jeff Crilly)

To: <yaesu@contesting.com>
Subject: [Yaesu] new member with a ft-101... (Jeff Crilly)
From: R_Davis" <WD8JJA@arrl.net (R_Davis)
Date: Thu, 14 Mar 2002 21:03:29 -0500
Hi Jeff,
If you can get her running good, the FT-101 (especially the E,EE,EX models),
is a terrific rig.  I still use mine after 25 years.  With proper care, I am
still using the tubes installed in 1977 and it will still do 125-175 watts,
depending on the band. Hopefully yours hasn't been hacked or cooked by a
CBer.  They did indeed work very well on CB (if it had the AM filter), but
if it is keyed down with more than 150mA for more than 10 seconds, it'll
burn the finals up and maybe some of the inductors.

1. The ACCessory plug is needed to jumper pins 1 and 2 to apply heater
voltage to the 6JS6C's. It also accesses the HV's (600, 300, 160, -100V),
the transmit/receive relay - ground on transmit and ground on receive, and
is the ALC input from a linear ie FL2100B.
They are offered on EBay all the time.

2. Can't tell you much about the lamps, I haven't had to replace any yet.
(Where is that block of wood I knock on?) I know the one over the VFO is
supposed to be a bear to get to.  I is a 14V, 40 mA wire lead type.  You
have to remove the main tuning knob and the escutcheon which is held by 2
screws. The other 3 are indeed 16V bayonet types.  I would would check with
Radio Shack.  You might get lucky (R.S. doesn't seem to have much anymore).
Yes I said 3 - There is one for the meter, one for the dial, and one in the
rear near the RF jack which is used as an RF fuse to protect the front end
from damage in the presence of too strong of a nearby signal.

3. I found a 12 pin Cinch-Jones plug for the power at a local electronics
shop, and  made my own DC Power cord. You will need the schematic as it is
internally jumpered on several pins so the same plug can be used on AC and
DC.  BE CAREFULL!!! The Cinch-Jones plug fits and looks identical, but the
pin numbers are reversed from the Japanese version.  It is a mirror image.
So you can have your own fireworks if you wire it up like the book shows.

4. I HIGHLY and STRONGLY recommend getting the Service Manual, sometimes
available on EBay, and some other Amateur Radio manual vendors such as A.G.
Tannenbaum's may have it.

Also there was the Fox Tango Club that put out newletters from 1972 to 1985.
Around then, International Radio took over and they sell back issues.  You
can get the whole library for $65.00.  You will learn a lot if you read them
through.

Have fun and good luck.
73's,
Rick WD8JJA

----- Original Message -----
From: <yaesu-request@contesting.com>
To: <yaesu@contesting.com>
Sent: Monday, March 11, 2002 12:02 PM
Subject: Yaesu digest, Vol 1 #146 - 1 msg


> Send Yaesu mailing list submissions to
> yaesu@contesting.com
>
> To subscribe or unsubscribe via the World Wide Web, visit
> http://lists.contesting.com/mailman/listinfo/yaesu
> or, via email, send a message with subject or body 'help' to
> yaesu-request@contesting.com
>
> You can reach the person managing the list at
> yaesu-admin@contesting.com
>
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of Yaesu digest..."
>
>
> Today's Topics:
>
>    1. new member with a ft-101... (Jeff Crilly)
>
> --__--__--
>
> Message: 1
> From: "Jeff Crilly" <jlc@myrealbox.com>
> To: <yaesu@contesting.com>
To: <yaesu@contesting.com>
> Date: Mon, 11 Mar 2002 00:44:44 -0800
> Subject: [Yaesu] new member with a ft-101...
>
> Hi.. new member here... Jeff in the SF-BayArea.  Hopefully this is
on-topic.
>
> Sooo, as a result of the local ham swap, I'm the new owner of decent
> looking FT-101.  Has far as I can tell its somewhat of a late model unit
> as it has 160m.
>
> I didnt get the acc plug with it ( this is the plug that makes it xmit --
> some of the pins on the acc connector need to be shorted.)
>
> Also, the panel lights are out (16v bayonet bulbs).
>
> Receive seems pretty good... though I just used a short wire for the
> antenna.
>
> I noted there are a few mods -- the schematic has some notes, but
> I havent deciphered it all yet.  There is a new 1/8" jack on the rear
> which is wired into a spot near the ALC setting.. I'm not sure what
> this is for. (Unfortunately, a 1/4" microphone jack was added to the
> front panel.. oh well, its not too noticable -- I didnt tell I got it
home.)
>
> Its possible that the capicator mod has been done for to use non-JA tubes.
> There are some notes on that.
>
> Anyhow.. I've been poking around on the web trying to learn more about
> the radio.. and I've see a few sites, but not really alot of info or
sources.
>
> Anyhow, anyone have any ideas on where to get an ACC plug and panel lamps?
> I'm also thinking of getting a new AC and DC plug (though I may rewire the
> AC cord.)  Will I have any luck at the local radio shack for the lamps?
>
> thanks
>
> jeff - n6zfx
>
>
>
>
>
>
> --__--__--
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
>
> End of Yaesu Digest
>

<Prev in Thread] Current Thread [Next in Thread>