Hi Jeff
Yes it is as simple as that. I did not use the ALC connection but made sure
that the drive power was always less than 60watts and this gave me full
output and a nice clean signal. I now run the AL80B the same way. Remember
to switch on the slider switch at the back of the MP to activate the relay!
73
Jim MM0BQI
----- Original Message -----
From: "Demers, Jeffrey" <Jeffrey.Demers@merrimack.edu>
To: <yaesu@contesting.com>
Sent: Thursday, November 07, 2002 8:58 PM
Subject: [Yaesu] ft1000mp mark-v with Al-811
> Greetings,
>
> I want to hook up the ft1000mpmkv with an ameritron al-811. Is it as
simple
> as hooking the 'tx ground' to the amp relay, and the connecting the ALC
> jacks or is it more complicated?
>
> Any help here is appreciated.
>
> 73 jeff n1snb
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
> text/plain (text body -- kept)
> text/html
> ---
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
|