Yaesu
[Top] [All Lists]

Re: [Yaesu] FL2100 to 1000MP help

To: "Michael Ruttenberg G7TWC" <g7twc@rutty.eclipse.co.uk>,<yaesu@contesting.com>
Subject: Re: [Yaesu] FL2100 to 1000MP help
From: <k9mi@sbcglobal.net>
Date: Tue, 21 Aug 2007 14:19:16 -0000
List-post: <mailto:yaesu@contesting.com>
I believe the "50 volts" you are referring to, is probably the voltage on 
the amp relay. Not good with most modern rigs, and most modern amps just 
have around 12 volt relays.  You will need a cable that has some kind of 
protection circuit in it, or you will fry the relay on the 1000 MP. I think 
several places sell these. Maybe someone will see your post and know what 
kind of cable you need. It can probably be homebrewed if you're so inclined. 
Surely someone around who runs a 2100 or a Heathkit SB220 or some older amp 
that has a high voltage relay. I'm fairly certain you would damage your rig 
if you used a straight through cable.

Mike, K9MI


----- Original Message ----- 
From: "Michael Ruttenberg G7TWC" <g7twc@rutty.eclipse.co.uk>
To: <yaesu@contesting.com>
Sent: Tuesday, August 21, 2007 11:10
Subject: [Yaesu] FL2100 to 1000MP help


> All,
>
> I recently bought an FL2100 (not a model B or Z, just plain 2100, 
> 80m-10m). 50V was mentioned but I don't know the significance of it.
>
> Any ideas how I drive this from the FT1000MP? I don't have a manual (or at 
> least it hasn't arrived yet from the seller).
>
> Thanks in advance
> Mike
> G7TWC (newbie to amps)
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu 

_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu

<Prev in Thread] Current Thread [Next in Thread>