...FT-757GX that has a slight problem. The frequency display is a little bit
out of calibration. It is off by the same amount in the given direction no
matter what frequency, band or mode. For example if talking on 28.427.0 USB
the digital display reads 28.426.8... As well if I were to go to 3.950.0 LSB
the digital display reads the same percentage off the actual frequency. The
same is observed in CW mode as well. The amount of discrepancy is the same
percentage in all modes though the "direction" of the error is either + or -
depending on mode. (normal)
The service manual (Technical Supplement) does provide information on aligning
the local unit. After the alignment to the components, per spec, the
discrepancy still remains in the digital display.
...Are there things we are missing?
...Is there an "alignment" for the digital display that is either being
overlooked or perhaps that is not in the Tech Supp?
...Any help would be much appreciated.
Thank You
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|