| To: | Yaesu Reflector <yaesu@contesting.com> |
|---|---|
| Subject: | [Yaesu] G-1000 DXA calibration |
| From: | Mike <nf4l_NO_SPAM@nf4l.com> |
| Reply-to: | nf4l@nf4l.com |
| Date: | Sat, 12 Sep 2009 18:57:33 -0400 |
| List-post: | <yaesu@contesting.com">mailto:yaesu@contesting.com> |
On page 8 of the manual, in item 7, there is mention of two raised calibration marks. My rotor has three, the one on the base and two on the rotating bell. The two on the rotating bell are roughly 90 degrees apart. One is above the mold mark (or separation) and one is below. Which one is the correct one to use for the alignment procedure? Neither is aligned with the mark on the base. 73, Mike NF4L _______________________________________________ Yaesu mailing list Yaesu@contesting.com http://lists.contesting.com/mailman/listinfo/yaesu |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Yaesu] G-450A Plugs, Larry K4AB |
|---|---|
| Next by Date: | Re: [Yaesu] Yaesu Digest, Vol 81, Issue 6, Carlos Adolfo Peña |
| Previous by Thread: | [Yaesu] G-450A Plugs, Larry K4AB |
| Next by Thread: | Re: [Yaesu] Yaesu Digest, Vol 81, Issue 6, Carlos Adolfo Peña |
| Indexes: | [Date] [Thread] [Top] [All Lists] |