Yaesu Items For Sale -- HF transceiver,
microphones, cables, HT accessories, and more
Heath SB1400 HF Transceiver (similar to Yaesu FT-747):
This is a 100 watt multimode HF transceiver covering 160 to
10 meters (including WARC bands). It operates on SSB, CW,and
AM. The receiver is very sensitive. This rig has noise blanker,
squelch, adjustable AGC and attenuator, as well as memories
and two VFOs. A narrow CW filter is included. It even has a
computer interface and is very similar to the Yaesu FT-747.
This one works 100% and looks very, very nice.
It includes power cord and paper work for $300.
Heath SB-1400-2 hand microphone
This hand mic is basically the same as a Yaesu MH-1, but with a
Heath label. Use it with the SB-1400 above, or with Yeasu rigs
with the round 8 pin connector. Like new for $40.
Heath HN-31 "Cantenna" RF Dummy Load:
This is the traditional Heath dummy load that will handle a
kilowatt. It has a derating curve both printed in the manual
and on the can.
It is in good shape both electrically and cosmetically. The
cantenna has no rust, dents or dings.
I can ship it either with or without oil. The cost to purchase
is the same, but of course the shipping will be higher with
Paper work is included for $40.
Heath SB-634 Station Console with Wattmeter:
The Heathkit SB-634 station console is a multifunction unit.
It contains a 24 hour digital clock (6 large digits, including
seconds), 10 minute interval timer (3 digits -- minutes and
seconds), phone patch and an SWR/Power meter. The large
wattmeter reads either 200 watts or 2000 watts full scale,
in addition to SWR. It matches the Heath SB series of equipment
(Heath green), and is powered by 115 V AC.
This unit works on all of its functions. It looks extremely
nice. I can not find a scratch on it, but there is very slight
(and I emphasize very slight) wear on the 2000 watt push button.
With paper work for $150.
HF and VHF SWR Bridges:
All of these cover from 3 to 150 MHz, covering HF, 6 meters,
and 2 meters. SO-239 connectors.
This unit features two separate meters -- one for reading
forward power and another for reading SWR. This permits one
to easily monitor both the power going out, and the SWR on
the antenna at the same time.
It works fine and looks great. With paper work for $37.
Carter Craft 90-300
Single Meter SWR Bridge / Field Strength Meter
This one works fine. I am 99% certain it has not been used,
except for my testing it.
In its original box with original instructions and little
field strength antenna. $30
Royce 2-100 Single Meter SWR Bridge / Field Strength Meter
This one works fine, and looks extremely nice. I do not see
any scratches on it, but it does have a previous owners name
on it. In its original box with original instructions. $28
Astron RS-20A Power Supply:
The RS-20A is a DC Power Supply producing 13.8 V DC (internally
adjustable from 11 to 15 V DC) at up to 16 amps continuous and
20 amps ICS. The RS-20 features crowbar over voltage protection
and fold-back current limiting to protect your equipment.
This particular supply works fine, and looks very close to new.
I do not find a scratch on it.
With paper work for $60.
Cables for Heil (and other) Microphones:
Heil CC-1 XLR 4
4 pin XLR Female to 3 pin XLR Male $25
3 pin XLR to stripped ends
About 10 feet of quality rubber covered mic cable with a 3 pin
XLR connector on one end. Ideal to add your own connector.
Can be used with the CC-1 XLR-4 above. $20
Regular round desk stand
Round 6 inch diameter heavy black / dark grey base, with
a 3 inch chrome tube coming up from the middle.
Standard 5/8 inch threaded. $15
Electro Voice Mic Holder
Gray colored EV, designed to hold 5/8 to 3/4 inch diameter mics,
and go into a stand with standard 5/8 inch threads. $5
Chrome Mic holder
Similar to EV holder, but chrome metal with a green felt on the
inside to protect the mic. For 1/2 inch to 5/8 inch diameter
microphones. Standard 5/8 inch threads. $5
Yaesu MH-1 Hand Microphone:
The Yaesu MH-1 b8 is the hand mic that is used on most of
the Yaesu HF and some of the Yaesu VHF rigs. It is a hand
mic that has a switch on the back with two audio frequency
responses -- one for rag chewing, and one for more punch
for DX. It has up and down switches, in addition to a
"fast" switch. Of course it also has the normal PTT
switch. It has a round 8 pin mic connector, wired for
This particular microphone looks like it might not have
ever been used. I think it was probably put in a drawer
when new, and left there. Of course it works fine. $38
Yaesu MH-31 B 8 dynamic hand microphone:
This is the Yaesu hand microphone that has the round 8
pin connector on it. It will go with virtually any Yaesu
rig that uses the round 8 pin connector. It has up, down,
and fst switches, and well as a tone switch, in addition
to the PTT switch.
This particular unit works 100%, and appears to be unused.
Yaesu YM-31 hand microphone
The Yaesu YM-31 is a hand mic with a round 6 pin
connector. Apparently it is either similar or the
same as the MH-25A6j (not the MH-25 with the 8 pin
connector). It is a 600 ohm impedance hand microphone,
and has a Monitor on-off switch on the back. It should
be compatible with any of the Yaesu rigs that uses the
round 6 pin connector. It looks very similar to the
This one works fine and looks extremely nice. $25
Yaesu YM-22 DTMF Condenser Microphone
This mic has a 16 digit touch tone (DTMF) pad on the front.
There are up and down buttons on the top, in addition to
the PTT switch.
Stripped and tinned ends. Great condition. $40
Yaesu MH-34 b 4 b speaker microphone
This is the one that fits the Yaesu VX-8, VX-7, VX-6,
VX-5, VX-3, VX-2, VX-1, and that series of HTs. I
think it also fits the FT-50 and FT-60, and maybe
others. It has a single 4 conductor, 3.5 mm plug on
it. This one is just like new. $35
Yaesu YM-24 A speaker mic.
Fits FT-207, 208, plus many others. It has the odd
little round connector on it like Yaesu, Wilson, and
others used in the 1970s and 80s. This particular unit
works fine, and looks great also. $20
Pryme Speaker Microphone
This is the equivalent of the Yaesu MH-34 (above). It
has the 4 conductor 1/8 inch plug on it. It works 100%
and looks like it has not been used. $28
This is the rounder style speaker mic that fits nicely in
the palm of your hand. Has 3.5 mm and 2.5 mm plugs for
Azden, Icom, some Yaesu, and others. $ 20
Pryme Speaker Microphone
This speaker mic has the 2.5 mm and 3.5 mm molded connector
as used by Icom, Alinco, Radio Shack, some Yaesu, and others.
It works fine and look line new. $20
MFJ-287 Speaker Microphone
This fits the TH-21/31/41 series HTs, TH-205, TH-215, TH-415,
as well as others. It has a 3 conductor 3.5 mm plug and a 2
conductor 2.5 mm plug.
It works fine, and looks close to new. $15
Yaesu HT Accessory Items:
Battery pack for Yaesu VX-2 or VX-3 HT
Lithium Ion Battery Pack fits both the VX-2 and the
VX-3. 3.7 volts, 1200 mahr, works great, and holds a charge
like new. $15
Yaesu NC-18 B Charger
Provides 14.5 V DC at 50 ma to charge many different HTs,
including the Yaesu FT-411, FT-811, FT-911, FT-23, FT-209,
FT-415, FT-410, FT-470, FT-727, FT-530, FT-703, and more.
Small 2.5 mm male plug. $10
Belt Clip for Yaesu FT-207, with hardware. $8
Wrist Strap for Yaesu FT-209, and probably others $4
Prices do not include shipping from Florida.
I also have many other accessories available such as many
different types of HTs, VHF and UHF rigs, HF and VHF/UHF
Just too many to list here. Please e-mail your requests.
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
Yaesu mailing list