Amps
[Top] [All Lists]

[AMPS] Padding Caps Discussion

To: <amps@contesting.com>
Subject: [AMPS] Padding Caps Discussion
From: k0wa@southwind.net (Lee Buller)
Date: Tue, 29 Apr 1997 12:12:13 -0500
At 11:12 PM 4/28/97 -0700, you wrote:

>No, but I just might. That is a damned clever idea. 
>
>Was your capacitance calculation affected much by the dissimilar size of
>the "plates?" Or was a straightforward calculation accurate enough?
>-- 
>Garry Shapiro, NI6T
>Editor, "The DXer," newsletter of the NCDXC
>Visit the Northern California DX Club 50th Anniversary page:
>http://www.aa6g.org/ncdxc50.html
>
No, I figured the surface area of the teflon square plus the thicknets and
guessed.  I would thing that you could do better calculations that I could.
The chasis acted as the ground side of the cap and seemed to not affect it.
I had calculated for about 500 pf, which if I remembner correctly around a
4" square.  I kinda guessed at it all, but I could get the tank to resonate
on 150 throuhgout the whole band with the 200 pf capacitor I was using for
the plate tuning control.  The teflon has a breakdownn voltage of 2000 volts
per mil if I remember right.   I think the piece I used would have taken
about 10,000 volts.  Alot of what I did was by the seat of my pants.  Got
the idea from a QST article in the 70s.  That is what I remember.

Lee
k0wa@southwind.net


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com

<Prev in Thread] Current Thread [Next in Thread>