Harvey,
You should check the neutralization the way I described in my
reply to Ian. It is safer and also works better.
As for the low power, is filament voltage OK? Can you bring a lead
out from the grids and measure the grid bias under drive to see if it
greatly increases??
What is the input SWR?
Assuming you have a reasonably accurate power meter, what is
the efficiency when you "peak it all up" on say 40 meters?
73, Tom W8JI
W8JI@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|