I have owned, serviced, and refurbished several of this
series. I find that if operated by the manual instructions,
these amps and tubes last a long time. Most I have gone
into have the original tubes, and they are 100%.
The filament winding was set up for 115/230 volts input.
If you have stiff 245 volt mains like I do, you might want
to look at the voltage at the tube pins to make sure it is not
over the Eimac limits.
(((73)))
Phil, K5PC
Phil Clements
410 VZ CR 4903
Ben Wheeler, TX 75754
----- Original Message -----
From: "Aubrey Bilbo" <bilboag@datasync.net>
To: <amps@contesting.com>
Sent: Sunday, September 09, 2001 11:37 PM
Subject: [AMPS] MLA2500
>
> Hello to All,
> I'm seeking info on the Dentron MLA2500. I know the tubes are pricey, but
> what are some of the problems that have been encountered with this amp.
> Operating quirks, hardware problems etc.
> Thanks,
> Aubrey, KE5LT
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|