-----Original Message-----
From: Bill Smith <ko4nrbs@yahoo.com>
To: amps@contesting.com <amps@contesting.com>
To: <amps@contesting.com>
Date: 25 December 2001 19:25
Subject: [AMPS] Isolation Transformer Voltage
>
>I came across a Power Conditioner that was being
>tossed out. I stripped everything out but the
>transformer so I could use it as an isolation
>transformer. I was hoping to get the input voltage to
>the my amps down to about 118 to 120 or so. I want to
>make sure the Filament voltages are not too high as
>they are on the high limit of the tubes now.
Something I've used is to add a low voltage transformer in series with the
line in antiphase to reduce voltage - perhaps 4V at 10 or 20A or so in your
case.
Steve
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|