Amps
[Top] [All Lists]

[Amps] 4-400A Plate

To: <amps@contesting.com>
Subject: [Amps] 4-400A Plate
From: mark@sandlabs.com (mark)
Date: Mon, 11 Nov 2002 11:07:12 -0500
I dought very much that the Anode is made of pure Tantalum, as this
materiakl is veri brittle in this form.
Also VERY expensive :)
For more about Tantalum go to :
http://www.tanb.org/

Most of the Tatalum today, (99%) is used in the fabrication of high
capacity, small form factor capacitors.
Pure tantlaum sells for about 125 usd an lb in ingot or cap grade powder.

A pure Tantalum Anode to resist the "white hot" temperature (a bit under
2996 deg. C) should cost around
$1000 :)

Mark

----- Original Message -----
From: "Peter Chadwick" <Peter.Chadwick@zarlink.com>
To: "amps" <amps@contesting.com>; "'Bill Fuqua'" <wlfuqu00@uky.edu>;
"'mark'" <mark@sandlabs.com>
Sent: Monday, November 11, 2002 10:24 AM
Subject: RE: [Amps] 4-400A Plate


> Mark said:
>
> >What is the use of the "glow" ??? Just wated energy :)
>
> In the case of a tantalum anode tube, the glow means that the plate is hot
> enough to absorb gas - a few metals have this property - so tantalum anode
tubes
> are meant to be run so hot.
>
> In any case, there's no more waste of energy than in a tube running at the
same
> efficiency and RF output with no glow.
>
> 73
>
> Peter G3RZP


<Prev in Thread] Current Thread [Next in Thread>