[Amps] Why hasn't solid state replaced tubes?

To:	<amps@contesting.com>
Subject:	[Amps] Why hasn't solid state replaced tubes?
From:	af4mp at mindspring.com (Zyg Skrobanski)
Date:	Tue Mar 4 07:32:18 2003

>IMD (splatter) is not considered spurious emissions by ICOM. All that tells
>you is harmonic suppression.

Is the IMD normally measured by using a two-tone test?  If so, does the
particular frequency of the tones (within a normal audio 3KHz bandwidth)
change the IMD, i.e. which two tones would give the worst case reading?
--
Zyg AF4MP
Roswell GA USA

<Prev in Thread]	Current Thread	[Next in Thread>
[Amps] hear hear about the toobs, (continued) [Amps] hear hear about the toobs, Tom Rauch [Amps] hear hear about the toobs, Tom Rauch [Amps] Why hasn't solid state replaced tubes?, Pete Smith [Amps] Why hasn't solid state replaced tubes?, Tom Rauch [Amps] Why hasn't solid state replaced tubes?, Zyg Skrobanski [Amps] Why hasn't solid state replaced tubes?, Tom Rauch [Amps] Why hasn't solid state replaced tubes?, Zyg Skrobanski [Amps] Why hasn't solid state replaced tubes?, Merv Schweigert [Amps] Why hasn't solid state replaced tubes?, Zyg Skrobanski [Amps] Why hasn't solid state replaced tubes?, Tom Rauch [Amps] Why hasn't solid state replaced tubes?, Zyg Skrobanski <= [Amps] Solid State Amps: 1500 watts is cheap if . . ., Steve Cloutier, 978-597-3311 [Amps] Solid State Amps: 1500 watts is cheap if . . ., George K. Watson [Amps] hear hear about the toobs, 2

Previous by Date:	[Amps] Radio shack power meter info, Martin Sole
Next by Date:	[Amps] 8877s, ETO and the General Electric Contract, RFlabnotes@aol.com
Previous by Thread:	[Amps] Why hasn't solid state replaced tubes?, Tom Rauch
Next by Thread:	[Amps] Solid State Amps: 1500 watts is cheap if . . ., Steve Cloutier, 978-597-3311
Indexes:	[Date] [Thread] [Top] [All Lists]