Frank, et.al.,
The first thing to do is to nul the SWR by adjusting C4, the trimmer in the
bridge circuit.
Some information is at:
http://www.qsl.net/kb7rgg/heath/Service_Bulletins/sb-hmxxx.doc
This does not require a viewer program.
I assume there is some calibration of the various ranges by putting another
known watt meter in series with the HM102 and a good 50 ohm dummy load and
adjusting for an equal readings.
George K8GG
----- Original Message -----
From: "Frank Mayer" <domino@worldlynx.net>
To: <Amps@contesting.com>
Sent: Monday, October 06, 2003 8:50 AM
Subject: [Amps] HM-102
> Does anyone know the alignment procedure for the HM-102 Heathkit
wattmeter?
> I have no manual. Thanks.
> Frank, WY3D
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|