k7fm wrote:
"I'm in need of 18 ga enamel coated wire for winding
toroid inductors."
Fortunately, I see that a source was found. However, I am slightly
surprised and mildly disappointed that there was nary a single suggestion
that he should obtain some #14 and tie one end to a bumper and the other end
to a tree and drive until the #14 became #18. That would have been in the
true ham spirit.
But then he would have had to anneal it before he could wind it around
the toroids! Not to mention get a new bumper, given their construction
these days.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|