Amps
[Top] [All Lists]

Re: [Amps] New Panasonic Tube Radio

To: "Harold B. Mandel" <ka1xo@juno.com>
Subject: Re: [Amps] New Panasonic Tube Radio
From: R.Measures <r@somis.org>
Date: Tue, 7 Sep 2004 04:29:50 -0700
List-post: <mailto:amps@contesting.com>

On Sep 6, 2004, at 9:42 PM, Harold B. Mandel wrote:


Oh, it's a sad, sad story, Mark.

For some guys, it's like "Losing The Lottery."

Denny's LK-series sure had a huge following.

The good thing about the LK-series was that they were the first g-g amplifier to use tuned inputs with a Q that was high enough for solid-state radios.


His outboard tranny
triple 3-500Z (LK-550) was a great start. I can imagine he woulda
worked out the kinks if Atilla The Hun hadn't grabbed the throttle.

As I understand it, there would have been no opportunity to grab the company if Denny and his secretary had not been caught in flagrante delicto by Denny's wife, who subsequently filed for divorce, and, as a result, Amp Supply Co. had to be sold in the community property settlement. /// As to working out the kinks, I am doubtful. To wit: Denny sent the MLA-2500 prototype to Eimac for evaluation. Eimac attempted to help Denny correct the RF faux pas in the MLA-2500, but he discarded their 'how to improve the design report' and went into production. Hubris was probably part of the reason for this, but Eimac's report would seemingly be difficult to comprehend for someone who either did not take AC circuit-analysis in college, or did not spend the time necessary to dig it out of the textbooks. Thus, unless Denny understood the fundamental reasons behind the needed changes, he would have been unlikely to see the need for implementing them. As a result, the return-rate on the 2500 was untenable.
- Murphy said that nothing is as easy as it looks.
cheers




Richard L. Measures, AG6K, 805.386.3734. www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>