Well it is actually amp related, or will be at some point I hope but seeing
how there is a great wealth of resource here it seems a good place to start.
Some time back I recall seeing an article, might have been in Radcom, might
have been in QST. Think it had to be either one of those two though. It
addressed the process of marking out metalwork for making enclosures and
explained how to allow the correct amount of material for bends etc. Was
within the last year or two I think.
Just hoping that somebody might recall where this was or maybe point me to
another resource with similar information.
Tks
Martin HS0ZED
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.7/60 - Release Date: 28/07/2005
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|