I've found this to be a very interesting thread. It is on topic, but
quite different than the usual subject matter.
Building chassis has been more of a hold up for me than the electronics
part of homebrewing amps. But I found some nice old cabinets at the
last ham fest I went to, so I'm about ready to get started now.
Where is a good place to buy sheet metal? Most of the places I have
found seemed awfully expensive.
73
Dan
--
K9ZF /R no budget Rover ***QRP-l #1269
Check out the Rover Resource Page at: <http://www.qsl.net/n9rla>
List Administrator for: InHam+grid-loc+ham-books
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|