Phil Clements wrote:
> I always use a power resistor of the correct wattage for the
> job, with a slider contact on it. This not only allows me to
> set the exact operating voltage at the tube pins, but it is
> also an inrush current preventor. I learned this from Henry
> Radio; used on many of their amps/generators.
>
> (((73)))
> Phil, K5PC
With the troubles I've read about with tube socket pins would
it not be better to come up with a scheme to measure filament
current?
73, Roger
--
Remember the USS Liberty (AGTR-5)
http://ussliberty.org/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|