Hello all, new to list and posting first time. Have a sb200 which has been
acting up a bit. Set up is Icom 751A driving the sb200 via ampkeyer
interface.
Has developed intermittent problem (is there any other kind) where when
transmitting and the mike is unkeyed, the receive stays dead. Thought I had
a bad jumper but replaced and it went back to same problem. Wiggling the
coax's will cause the receive to go in and out. I am not too much of a tech
and have the amp over at a friends for work but just wanting to get a feel
for what the experts say. Thinking possiblity of relay contacts or perhaps a
bad solder joint somewhere in the so239 areas. Any ideas?????
_________________________________________________________________
On the road to retirement? Check out MSN Life Events for advice on how to
get there! http://lifeevents.msn.com/category.aspx?cid=Retirement
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|