An oscillator, good mixer and a sound card running FFT should work. You
want to mix the RF down to around 10 kHz ( center of the sound card
frequency range) and observe sidebands around it.
You can use a sound card to also produce the two tone test signal to insert
into the SSB exciter.
73
Bill wa4lav
At 10:43 AM 8/11/2006 -0400, Martin AA6E wrote:
>Bill,
>
>I've wondered about this, too. The lab method is to use a high-priced
>spectrum analyzer, but couldn't you do something useful with a soundcard
>based spectrum analyzer? You would need to have a linear detector and a
>two-tone audio source. This would be similar to the IMD measurement you
>get with a PSK31 monitor. The trouble is you need pretty good dynamic
>range to measure a healthy system.
>
>You could check the boxes being sold by www.cleanrf.com as described in
>the latest CQ. They let you look at "linearity" on a scope. My take is
>that you will only catch gross non-linearity (overdrive), but you
>wouldn't get quantitative IMD numbers with this approach.
>
>73 Martin AA6E
>
>Bill Turner wrote:
> > Is there a simple procedure one can use for checking the IMD of an
> > amplifier? Frankly, it's something I have never tested myself, instead
> > just keeping the amp tuned correctly and underdriving when using SSB.
> > I've never gotten any complaints of splatter so I think it's under
> > control. Since I do mostly RTTY and some CW it has not been an issue
> > but I would like to be able to check it.
> >
> > Any recommended reading on the issue?
> >
> > Bill, W6WRT
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|