Why not use rubber hose?
Jim W7RY
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]
On Behalf Of mike kendall
Sent: Friday, August 11, 2006 9:34 AM
To: amps@contesting.com
Subject: [Amps] Mechanical question
Hello all,
I recieved the cold plate (liquid cooling plate that attaches to the
heat spreader) in for the linear project I'm working on. It has 1/8
inch copper tubing coming out of it for a couple inches and is designed
to have more copper brake line soldered/brazed to it. Is there a tool
that I could use to expand out the brake line a little so it will slip
over the other brake line and allow a good mechanical connection before
soldering?
73,
Mike
---------------------------------
Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls. Great
rates starting at 1¢/min.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|