Steve Cook wrote:
> Looking at the specs for the 2SC5125 output transistors used in the ICOM 756
> series transceivers. Spec sheet says they are rated for 80W output each or
> 160W per pair up to 175Mhz.
>
> Wondering why ICOM only runs them at 100W?
>
> There is an adjust pot that will allow the output to be turned up somewhat --
> up to around 150W.
>
> What is the undesirable effect of turning up the power to say... 125W, if any?
Nothing, if you only operate CW. But IMD would increase significantly,
producing a splatter-y SSB signal and making you unpopular.
--
Best Regards,
Vic Rosenthal
Transparent Software, Inc. -- RAKEFET
559.226.5147
Visit us at <http://www.rakefet.com>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|