In a message dated 5/20/2010 12:41:18 P.M. Eastern Daylight Time,
sub1@rogerhalstead.com writes:
I've been searching the Internet for suppliers of transformer E-I
laminations. I've found a few, but their web sites are difficult to
navigate and I never did find the specific laminations I wanted. That
and most of them are off shore industrial suppliers and I don't really
need a couple tons of the stuff.<:-))
73
Roger (K8RI)
Hi,
What sizes you are looking for?
I assume you want to build a power transformer?
I have had good dealings with Lamination Specialties Corp.
in Chicago, IL
They are very friendly and will accept small orders but
they do have a minimum order size of 1/2 string which is
660 sets of EI lams.
I bought a half-string of EI-175 lams from them about a year
ago ( 45lbs worth ) + UPS Ground shipping for $177. The price
on steel changes all the time so they will give you a current
quote.
You can reach them at :
sales@laminationspecialties.com
Also depending on what you want to build you may need some
Plastic Bobbins to fit, L-Brackets or Keeper Lams which I got
from RAM SALES CO.
73 Todd WD4NGG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|