Get out your calculator and figure out how much of a dB/S-meter increase
1100 watts is above 800 watts.
Then YOU can make the decision.
73
Jim W7RY
--------------------------------------------------
From: "Vic K2VCO" <vic@rakefet.com>
Sent: Sunday, May 08, 2011 11:01 PM
To: "Amps reflector" <amps@contesting.com>
Subject: [Amps] 4-400A ratings
> I've come into a pair of 4-400A's. I'm thinking about building an
> amplifier with one tube
> and using the other for a spare. Looking at the data sheet for class-C CW,
> the maximum
> rated plate current is 350 ma. This means that at 3 kV on the plate I can
> expect to get
> only about 750-800 watts output. This does not come close to utilizing the
> 400-watt plate
> dissipation of the tube.
>
> At 4 kV, I could get 1400 watts input and about 1050-1100 out. That's a
> lot better. But it
> means a lot of extra expense -- the power supply, tuning capacitor, etc.
> need to be bigger.
>
> Is this correct? Why is the plate current limited to 350 maA? Is it a
> limitation on
> filament emission?
>
> Of course I can use both tubes and get full legal power. But then I need
> another socket,
> chimney, etc. Or maybe I can use the "SB220 cooling method" and cheaper
> sockets.
> --
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco/
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1321 / Virus Database: 1500/3625 - Release Date: 05/08/11
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|