Amps
[Top] [All Lists]

Re: [Amps] 3-500 to 4-250 tube conversion

To: <amps@contesting.com>
Subject: Re: [Amps] 3-500 to 4-250 tube conversion
From: MIKE DURKIN <patriot121@msn.com>
Date: Thu, 16 Feb 2012 11:04:04 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Why not 3 GS35B ...?

Mike KC7NOA 

> From: km1h@jeremy.mv.com
> To: saveatpharmacy@gmail.com; amps@contesting.com
> Date: Thu, 16 Feb 2012 11:09:45 -0500
> Subject: Re: [Amps] 3-500 to 4-250 tube conversion
> 
> 10-4 good buddy
> 
> 
> ----- Original Message ----- 
> From: "kennon lewis" <saveatpharmacy@gmail.com>
> To: <amps@contesting.com>
> Sent: Thursday, February 16, 2012 2:58 AM
> Subject: [Amps] 3-500 to 4-250 tube conversion
> 
> 
> > hello. recently I received an amplifier with 6 bad 3-500z tubes in it. i
> > have a bunch of good 4-250 and 4-400 tubes on hand and am looking to
> > convert the amp to run on these tubes. the cost of purchasing 6 new 3-500
> > tubes is out of the question at this time. the amp covers 10 - 80 meters.
> > looking at the tube data it looks like all i need to do is strap pins 2 
> > and
> > three together with a low ohm resistor and that should do the job, one
> > being a triode and the other a tetrode. the power supply seems more than
> > adequate. any schematic help or other information will be greatly
> > appreciated. thanks ke5rgm
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >
> > -----
> > No virus found in this message.
> > Checked by AVG - www.avg.com
> > Version: 10.0.1424 / Virus Database: 2112/4813 - Release Date: 02/16/12
> > 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
                                          
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>