Amps
[Top] [All Lists]

Re: [Amps] warbleing gi-7

To: sam@owenscommunication.com
Subject: Re: [Amps] warbleing gi-7
From: Carey Lockhart <kc5gtt@gmail.com>
Date: Tue, 21 Feb 2012 13:58:17 -0600
List-post: <amps@contesting.com">mailto:amps@contesting.com>
i agree with all the sugestions you have presented guys. i had him check
the bias voltage, but i am not sure if he understood my instructions. he
did ground the rig and amp. how well i dont know. i am very diapointed that
my amplifiers have not been more UPS proof. that makes two now that have
had quirks after shipping. thanks

Carey, kc5gtt

On Tue, Feb 21, 2012 at 10:45 AM, Sam Carpenter
<Sam@owenscommunication.com>wrote:

> Agreed, I think he should look at the shielding on the audio inputs or any
> other input on his xcvr and also the station earth ground. It will need to
> be low impedance with short as possible run of silver braid, copper
> strapping,#6 stranded or #2 stranded if longer than 10' or the like. Also
> will want a good 8' ground rod. He should have a transmission line ground
> kit at the entrance to the shack going to a common ground. Stray RF will do
> all kinds of funny audio things and burn you sometimes too.
>
>
> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of Glen Zook
> Sent: Tuesday, February 21, 2012 11:01 AM
> To: Terry P; amps@contesting.com; KC5GTTCarey Lockhart
> Subject: Re: [Amps] warbleing gi-7
>
> It may be r.f. getting back into his exciter from the fact that more power
> is now being used.
>
> Glen, K9STH
>
>
> Website:  http://k9sth.com
>
>
> ________________________________
>  From: Terry P <n0pgr@yahoo.com>
> To: amps@contesting.com; KC5GTTCarey Lockhart <kc5gtt@gmail.com>
> Sent: Sunday, February 19, 2012 4:26 PM
> Subject: Re: [Amps] warbleing gi-7
>
>
>
> --- On Sun, 2/12/12, Carey Lockhart, KC5GTT <kc5gtt@gmail.com> wrote:
>
> From: Carey Lockhart, KC5GTT <kc5gtt@gmail.com>
> Subject: [Amps] warbleing gi-7
> To: amps@contesting.com
> Date: Sunday, February 12, 2012, 6:51 PM
>
> Hello Guys,
>
> Just sent a little 2m gi7b amplifier to a ham in idaho. he is getting a
> report of a warble in his audio with the amp in. to me that sound like
> arching cap what do yall think?
>
> Carey, kc5gtt
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> Carey ,
>
> If this amp is large enough to pull down the AC mains , this could effect
> the exciter .
>
> This would depend on things like the operator using AC power strips and so
> one .
>
> Just a thought
>
> Terry N0PGR
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>


-- 
Carey Lockhart, KC5GTT
Boerne, Tx. 78006
www.kc5gtt.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>